in logs or in boards, if in logs they are sawn on woodmizer machines, in boards they are sawn on rayman machines. after sawing the blanks, they go to drying chambers. we mainly use beech wood, oak, and alder. it is brought from all over belarus. dup mainly from the bretsky region, well, and alkha also from there from the south. signal to the computer, which is in separate. after the computer has moistened, it begins the drying process, dries, ventilates, wets, ventilates, in short, the process is long, from 30 to 60 days. drying is done without human intervention. the wood is dried to a moisture content of 8-10%. after the wood has been dried in the dryers, it goes to the splicing section, the optimization section, then it is cut into smaller. smaller blanks, where they are already spliced ​​along the length, along the width, knots, rot are selected, that is, all this is removed, the paths of transporting parts from this section to the main production is small, all parts are transported by forklifts, electric forklifts, everything happens quickly and reliably, i go into the transport sh

>> rayman gotten that far kaitlan, i think i and most other legislators would have questions about the cost to taxpayers or the cost and higher premiums. and as always, and ensuring that we respect the religious liberty rights of all americans. again, president trump and i support ivf as do all elected republicans. but i respect any american who has a different point of view, especially if there are health care provider or work with a catholic charity and they want their religious liberty respected. that's what we would do. democrats would not do that so if you're an american out there and you're someone who maybe is in alabama and you're worried about having access to ivf, not because the state is saying that they're going to make it illegal, but because there's no clinics open in the state because they're worried about supreme court rulings that that could imperil access to it and if the legislature had not acted, which they did under political pressure, if you're someone out there and you're looking at these two candidates here ahead of november donald trump and vice president harri